Table of Contents

How do I change my Apple Watch bumper?

Sarah Shoemaker Updated by Sarah Shoemaker

Some Base Stations that support Apple Watch charging include multiple rubber bumpers to support your Apple Watch during charging.

Two bumpers:

The smaller bumper that comes pre-installed is used for 42mm and 44mm Apple Watches. The taller bumper included in the box is used for 38mm or 40mm Apple Watches. If you will be charging a 42mm or 44mm Apple Watch, leave the smaller bumper in place. If you will be charging a 38mm or 40mm Apple Watch, remove the pre-installed bumper by peeling up at the edge. Install the new bumper by fitting one side in the groove and pressing down in a sliding motion. There is no glue or tape necessary.  

Four bumpers:

The bumpers are labelled to clarify which Apple Watch size each accommodates. To remove the currently installed bumper, peel it up from the edge. Install the new bumper by fitting one side in the groove and pressing down in a sliding motion. There is no glue or tape necessary.  

Check out this video we made for more installation instruction.

How did we do?

How do I install my Apple Watch charging puck to the mount?

Contact Us